HP Enterprise Systems Library (ESL) G3 Tape Library High Density Expansion Module Power Supply Installation and Replacement Instructions

ManualsBrandsHP ManualsStorageHP StoreEver ESL G3 100 slot Tape Library

HP StoreEver Enterprise Systems

Library (ESL) G3 Tape Library

High Density Expansion Module

Power Supply Installation and

Replacement Instructions

Abstract

This document describes how to remove and replace an existing

or install a new power supply in a High Density Expansion Module

(HDEM) in an ESL G3 Tape Library.

Printed in the US

*H5X00-96001*

HP Part Number: H5X00-96001

Published: May 2013

Edition: 1st

CAUTION: Parts can be damaged by

electrostatic discharge. Keep parts in their

containers until needed. Make sure that you are

properly grounded when touching static sensitive

components.

NOTE: If the power supply is redundant (there

is another one in the module), the power supply

is hot-swappable; you do not have to turn off

power to the library or module to remove and

replace a redundant power supply.

Inspect the contents of the kit

The kit contains one HDEM power supply.

You will also need the ESD strap that shipped with the

ESL G3.

Prepare the library

1. If you are replacing the only power supply in the

module, power off the library:

a. Make sure there is no I/O activity on any of

the partitions.

b. Make sure that you are viewing the physical

library. From the View menu or in the

Managed Views region of the Operator

Control Panel (OCP), click the name of the

physical library.

c. Select Operations→System Shutdown.

The System Shutdown dialog box appears

with Shutdown selected as the default.

d. Select Shutdown, then click OK in the

confirmation dialog box.

When the shutdown process completes, the

OCP display turns dark.

e. To turn off power to the library, press the

Power button on the indicator panel.

2. Open the service door to the module.

3. Attach the ESD strap to your wrist and to an

unpainted surface inside the door.

Page 1

Summary of content (3 pages)

PAGE 1
HP StoreEver Enterprise Systems Library (ESL) G3 Tape Library CAUTION: Parts can be damaged by electrostatic discharge. Keep parts in their containers until needed. Make sure that you are properly grounded when touching static sensitive components.
PAGE 2
Remove the power supply from the HDEM Install the power supply in the HDEM 1. 1. Vary off the tower using the operator panel on the HDEM service access door. 2. 3. 4. 5. Using the external handle on the power supply, slide the power supply onto the supporting rails at the top of the HDEM and into place. Tighten the thumbscrews to hold the power supply in place. Attach the power cable to the replacement power supply.
PAGE 3
. When the library is fully powered on and ready to receive commands, the Robotics Enabled indicator turns solid green. If this is a replacement, close the event that was generated for the failed power supply. HP web sites For additional information, see these HP web sites: • http://www.hp.com • http://www.hp.com/go/storage • http://www.hp.com/service_locator • http://www.hp.