HP StoreEver 1/8 G2 Tape Autoloader User and Service Guide (AK377-96024, December 2012)

• IPv4 DNS Server 1 and IPv4 DNS Server 2 — addresses of the configured DNS servers used
when DHCP Addressing is not Enabled.
• DHCPv4 Addressing — When Enabled, the device will request an IP address from a DHCP
server each time the device is booted.
• IPv4 Address — the autoloader network address
• Subnet Mask — The network mask of the autoloader controller used when DHCP Addressing
is not Enabled.
• Default Gateway — the gateway used when DHCP Addressing is not Enabled.
When IPv6 Addressing is Enabled, you can see, but not modify:
• Stateless Addressing — when Enabled, the device will generate an address for itself based
on the routing information obtained from a router advertisement and the MAC address. The
device can manage up to five global addresses at the same time, which can be assigned from
different routers.
• DHCPv6 Addressing — when Enabled, the autoloader will request an IP address from a DHCP
server each time the device is booted.
• Static Addressing — when Enabled, the device will use a statically-configured address.
• Static Assigned Address — the IPv6 address when Static Addressing Enabled is On.
Status
Viewing dynamic device information
The Status: Autoloader page displays dynamic information about the device. When you click
Refresh, the status is updated immediately.
Figure 33 Status: Autoloader page
You can see, but not modify, the following:
Remote management interface (RMI) 43