HP StoreEver 1/8 G2 Tape Autoloader User and Service Guide (AK377-96024, December 2012)

• Autoloader LUN Hosted by Drive — Yes, if this drive is hosting the autoloader at LUN 1. Will
always be Yes for the 1/8 G2 Tape Autoloader.
• Data Compression — Yes, if the host has hardware compression turned on for the drive.
• Interface Type — SCSI, Fibre Channel, or SAS
• WWide Node Name (FC drive only) — world wide unique number for the drive. The
autoloader assigns WWNames to the drive bays. When a tape drive is replaced, the
WWName is re-assigned to the replacement drive.
• Port information (FC drive only)
WWide Port Name — world wide unique identifier for the port. The WW Node and
Port Name will be slightly different.
◦
◦ Port Type — the current setting of the drive port. Direct connected devices are typically
Loop. Devices connected to a switch are typically Fabric.
◦ Speed
Viewing network information
The Identity: Network page displays information about the network configuration.
Figure 32 Identity: Network page
You can see, but not modify:
• MAC Address — a unique identifier for the autoloader controller network interface
• Full Qualified Domain Name — the fully qualified domain name for the device
• Clock Synchronization Configuration (SNTP) — When Enabled, the device will obtain the
current time and date from the configured SNTP server.
When IPv4 Addressing is Enabled, you can see, but not modify:
42 Operating the tape autoloader