HP StoreEver 1/8 G2 Tape Autoloader User and Service Guide (AK377-96024, December 2012)

Figure 1 Front panel overview
2. Mailslot1. Power button
4. Front panel LCD screen3. Front panel LEDs
6. Air vents5. Control buttons
7. Magazine
The operator control panel includes four LEDs that indicate system status information as shown in
“Operator control panel LEDs” (page 13).
Figure 2 Operator control panel LEDs
Ready. Illuminated when power is on. Blinking when there is tape drive or robotics activity.Green1.
Clean. Illuminated when the tape drive has determined that a cleaning cartridge should be used.
Cleaning is only necessary when the device directs you to do so. Additional cleaning is not
necessary.
Amber2.
Attention. Illuminated if the device has detected a condition that requires attention by the operator.Amber3.
Error. Illuminated if an unrecoverable error occurs. A corresponding error message displays on
the LCD screen (see Troubleshooting (page 87) for more information).
Amber4.
Back panel overview
The back panel provides access to the drive interface connectors, the tape drive, the power
connector, the Ethernet, serial and USB ports, and the magazine release holes as shown in
Figure 3 (page 14).
Figure 3 Back panel overview
2. Fan1. Tape drive assembly
4. Magazine release hole3. Power connector
6. Ethernet port5. Pull-out tab containing the serial number and other
product information
Back panel overview 13