HP StoreEver 1/8 G2 Tape Autoloader User and Service Guide (AK377-96024, December 2012)

Table 31 Robotic error sub-codes (continued)
DescriptionSub-code
Error during first slider
2
movement61
Error during first gripper
1
movement62
Error during second slider
2
movement63
Error during second gripper
1
movement, get range failed64
Error during third slider
2
movement, move home failed65
Release magazine failed70
Error during sled
5
movement to rotation
4
position71
Error during rotation
4
to unlock position72
Error during move sled
5
to block73
Opening mailslot failed80
Error during movement to mailslot open position81
Error during moving back, sensor was found82
Movement to home position failed90
Elevator
3
movement to home position failed91
Error during sled
5
movement to rotation
4
position92
Error during rotation
4
to home or far position93
Sled
5
movement to home sensor position failed94
Sled
5
movement to transport position failed95
Error during rotation movement to rotation minimum position99
Movement to mailslot failedA0
Sled
5
movement to sensor failedA1
Sled
5
movement to rotation
4
position failedA2
Elevator
3
movement to home position failedA3
Error during rotation
4
to far positionA4
Sled
5
movement to mailslot position failedA5
Error during elevator movement to positionA6
Error during mailslot detectionA7
EEPROM on robotics controller not accessible or error during read/write operationB0
Save/restore configuration settings: not enough internal memory available for creating the file and
restoring the file respectively
B1
Save/restore configuration settings: restore buffer corrupted, checksum calculation failedB2
Save/restore configuration settings: database field corruptedB3
Save/restore configuration settings: invalid personalityB4
Save/restore configuration settings: invalid fileB5
Check on magazine type failedC0
Rotation
4
movement during check on magazine type failedC1
Error codes 119