HP StoreEver 1/8 G2 Tape Autoloader User and Service Guide (AK377-96024, December 2012)

Table 31 Robotic error sub-codes (continued)
DescriptionSub-code
Error during sled
5
movement in FLMoveRotation31
Command sending to robotic failed32
Error during elevator
3
movement in FLMoveRotation function33
Error during rotation
4
in FLMoveRotation function34
Error during elevator
3
movement in FLMoveRotation function35
Error during sled
5
movement in FLMoveSled function36
Error during sled
5
positioning to sensor in FLMoveSled function37
Error during sled
5
positioning to mailslot in FLMoveSled function38
Error during sled
5
positioning without sensor39
Error during elevator movement without sensor3A
Error slot position sensor not found3B
Movement to/from slot failed40
Error during first slider
2
movement41
Error during first gripper
1
movement42
Error during second slider
2
movement43
Error during second gripper
1
movement, get range failed44
Error during third slider
2
movement, move home failed45
Error during set hold current to avoid torsion46
Negative direction blocked — the robot cannot move backward.47
Positive direction blocked — the robot cannot move forward.48
Robot is blocked in both directions.49
Cartridge present sensor failure.4A
Destination blocked or full.4B
Source location empty.4C
Could not pull tape out of slot.4D
Unexpected tape on elevator, possible inventory lost.4E
Preposition to drive failed50
Elevator
3
movement to home sensor failed51
Sled
5
movement to home sensor failed52
Error during sled
5
movement to drive position53
Error during rotation
4
to drive position54
Error during elevator
3
movement in drive position55
Error during sled
5
movement to rotation position.56
Error during rotation to end position.57
Move from/to drive failed60
118 Troubleshooting