6.3.3 HP StoreAll OS Release Notes (AW549-96082, January 2014)

• If StoreAll does not discover a node in your cluster, verify that the ibrix_discovery service
is running by entering the following command on the node that was not discovered: service
ibrix_discovery status
If the ibrix_discovery service is not running, enter the following command to start the service:
service ibrix_discovery start
• After a server is rebooted following a QR install and before the server is configured, an error
message reports that the SRVSVCD service failed to load. The failure occurs because the service
requires that the network subsystem be configured. The error message can be safely ignored.
After the network is configured, restart the SMB service.
• When entering values in any of the IP address fields in the ASCII UI Wizard, be aware there is
currently no limit on the number of numbers/characters entered. If you enter a very long value
and press OK to validate the entry, an error message will display. The only way to fix the error
is to press Backspace and clear the field. A fixed length on these fields will be implemented in a
future release.
LDAP
• When configuring LDAP on the GUI, double quotes are not supported in any fields of the LDAP
configuration window, including the password field. Also, escaped slashes are not supported. If
you enter \\; it will be parsed literally as \\ instead of \. Also, the ibrix_ldapconfig
command supports double quotes only at the beginning and end of a value. For example:
ibrix_ldapconfig -a -h 10.30.239.174 -b "cn=Manager,dc=ldapx,dc=net"
-p "mypassword "
The command does not support escaped slashes.
LDAP ID mapping
• Increasing the values of the LdapMaxWaitTime and LdapMaxEntries can affect the performance
of name resolutions for SMB and non-SMB users in large LDAP directory environments. The AD
name cache protects against excessive LDAP searches. The default value for these parameters is
10. The range of values is 0 (unlimited) or 1–32767.
Management console
• File system creation on the 9300 server fails from the Getting Started Wizard. No data loss or
corruption occurs, and you can still create the file system using the Create Filesystem Wizard or
its comparable CLI command (ibrix_fs -c -f...).
• File system creation from the Management Console, not the CLI, might sometimes fail with the
message Exporting filesystem (NFS) failed. The file system was created correctly and
all the other steps in the process have completed.
After creating a file system, you can create an NFS share and export the file system using either
the GUI or CLI, as described in the HP StoreAll Storage File System User Guide.
Platform support
• The FMT does not currently include firmware for the following disk drive models:
EG0300FCVBF◦
◦ MB1000FCWDE, MB2000FCWDF, MB3000FCWDH
◦ MB2000FCZGH, MB3000FCZGK
◦ ST2000M0033, ST1000M0033
26 Workarounds