6.3 HP IBRIX X9720/StoreAll 9730 Storage Administrator Guide (AW549-96073, June 2013)

Troubleshooting
Manually recovering bond1 as the cluster
If you are unable to use the installation wizard to recover bond1 as the cluster, perform the following
procedure:
1. Create bond0 and bond1:
a. Create the ifcfg-bond0 file in the /etc/sysconfig/network-scripts directory
with the following parameters:
BOOTPROTO=none
BROADCAST=10.30.255.255
DEVICE=bond0
IPADDR=10.30.3.16
NETMASK=255.255.0.0
ONBOOT=yes
SLAVE=no
USERCTL=no
BONDING_OPTS="miimon=100 mode=1 updelay=100"
MTU=1500
b. Create the ifcfg-bond1 file in the /etc/sysconfig/network-scripts directory
with the following parameters:
NOTE: When creating the ifcfg-bond1 file, enter the cluster network IP address and
mask for bond1.
BOOTPROTO=none
BROADCAST=172.16.7.255
DEVICE=bond1
IPADDR=172.16.3.16
NETMASK=255.255.248.0
ONBOOT=yes
SLAVE=no
USERCTL=no
BONDING_OPTS="miimon=100 mode=1 updelay=100"
NOTE: In this step, the MTU parameter is not displayed because it is optional.
2. Make the eth ports slaves to bond0 and bond1:
a. Add the following lines to the ifcfg-eth0 and ifcfg-eth3 files in the /etc/
sysconfig/network-scripts directory:
MASTER=bond0
SLAVE=yes
b. Add the following lines to the ifcfg-eth1 and ifcfg-eth2 files in the /etc/
sysconfig/network-scripts directory:
MASTER=bond1
SLAVE=yes
Troubleshooting 165