HP SureStore E Disk Array XP512 Site Prep Guide

Preparing for Installation 57
Be sure to connect a power cord to the distribution box as illustrated in the
figure below. To reduce the risk of a wrong connection, use a socket
approved for this disk array.
High leakage current may occur between the power supply and the unit. To
avoid an electrical shock, be sure to perform the protective earth connection
before the supply connections are made.
Branch Circuit Requirements
To protect your disk array, your building must be wired correctly. Each line
(U/L1, V/L2 line) should be protected by a short circuit protective device
and by an overcurrent protective device rated 20 amp on building
installation.
The protective device on building installation shall be comply with
National Standards of the country where the units shall be installed, and if a
protective device interrupts a conductor, it shall also interrupt all other
supply conductors.
G
r
e
e
n
/
Y
e
l
l
o
w
B
l
u
e