HP StorageWorks Disk Array XP operating system configuration guide: Windows NT (A5951-96023, December 2005)

5. Select “Advanced Adapter Settings” and set the value of “ENABLE TARGET RESET”

to YES.

To conﬁgure in an M

SCS environment:

• After sy stem startup, go to Conﬁguration Settings, click Advanced Adapter Settings,

and verify the following settings:

>4Gbyte Address

ing: enabled

enable LIP Reset: yes

enable ta rget reset: yes

Conﬁguring Emulex LP6000E, LP7000/E, or LP8000

adapters

CAUTION:

The following procedure utilizes the Registry Editor and is intended for the system

administrator. Use the registry editor with extreme caution. A lways use regedt32

instead of regedit. Do not make any changes to the system registry other than those

speciﬁed below. If you have questions, please contact the HP service representativ e

before beginning this procedure.

Youmustedittheboot.ini ﬁ le as follows to enable both of the dual power-control

interface (PCI) buses of the d isk array to recognize the LP6000E, LP7000/E, or LP8000

adapter. Then conﬁrm the disk I/O time-out setting.

1. During system startup when the ﬁrst blue screen appears, press F6 to access the

Windows NT setup utility.

2. Use Notepad (or another text editor) to open the boot.ini ﬁle.

You may need to disable the read-only ﬁle attribute to edit the ﬁle (use the Windows

File-Properties panel, or the DOS attrib command).

3. Add the /PCILOCK option to the system boot entries.

4. Close boot.ini, and save your changes. You must reboot the system for these

changes to take effect.

5. From the Run menu, open regedt32,theregistryeditor.

6. From the Registry Editor, select:

HKEY_LOCAL_MACHINE→

SYSTEM→

Fibre Channel adapter settings