HP StorageWorks Disk Array XP operating system configuration guide: Windows NT (A5951-96023, December 2005)

Setting the host mode for the disk array ports

After the disk array is installed, you must set the host mode for each disk array port to

match the host OS. Set the host m od e using LUN Manager in Remote Web Console XP

(shown), Command View XP, or Command View XP Advanced Edition. If these are not

available, t

he HP ser vice representative can set the host mode using the SVP.

The available host mode settings for Windows N T are as follows:

Host M ode

Description

HP recommended. Do not use with Agilent D8602B HBA.

For Agilent D8602B HBA only, with or without MSCS (clustering).

For Fibre Channel HBAs without MSCS (clustering) Not

recommended by HP.

Installation