HP StorageWorks Disk Array XP operating system configuration guide (A5951-96014, August 2004)

16 HP StorageWorks Disk Array XP Operating System Configuration Guide: HP-UX
Install and configure the disk array
The HP service representative performs the following tasks:
• Assembling hardware and installing software
• Loading the microcode updates
• Installing the channel adapters (CHAs) and cabling
• Installing and formatting devices
You perform the additional tasks below. If you do not have Command View
or LUN Configuration Manager, your HP service representative can
perform these tasks for you.
Setting the Host Mode for the disk array ports
The disk array ports have Host Modes that you must set depending on the
host you use. After the disk array is installed, use Command View (shown)
or LUN Configuration Manager to set the Host Mode for each port.
The host mode setting for HP-UX is 08.