HP StorageWorks XP12000 Disk Array Site Preparation Guide (AE002-96040, March 2008)

Figure 15 Removing the outer carton
2. Cut and remove the polyester bands.
3. Remove the nails attaching the carton to the pallet.
4. Remove the plastic carton fasteners.
5. Remove the carton.
Steps 6 through 8 refer to Figure 16.
5. Ramp4. Accessory boxes
7. Poly bag6. Corner pads
Figure 16 Unpacking the inner wrapping
6. Remove the accessory boxes, ramp, and corner pads.
7. Using a 6mm hex and 19mm wrench, remove the adapter plates that anchor the rack to the
pallet.
8. Remove the poly bag covering the rack.
9. Following the instructions provided on the wooden ramp, attach the ramp to the pallet and roll
the rack onto the floor.
10. Visually check the unit for any damage. If any damage is visible, report it immediately to HP and
the shipping carrier.
XP12000 Disk Array Site Preparation Guide 63