HP StorageWorks XP SNMP Agent Reference Guide: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96056, May 2011)

NOTE: For example, the object identifier for a failure in a disk controller processor would be
1.3.6.1.4.1.116.5.11.4.1.1.6.1.2.
Standard MIB Specifications
Supported MIB
Table 9 (page 20) shows the supported MIBs. If you send a GET request for an object (MIB) that
is not supported, you will receive NoSuchName as a GET RESPONSE.
Table 9 Supported MIBs
Supported?MIB
Supportedsystem groupStandard MIB: MIB-II
Not supportedinterface group
Not supportedat group
Not supportedip group
Not supportedicmp group
Not supportedtcp group
Not supportedudp group
Not supportedegp group
Not supportedsnmp group
SupportedExtension MIB
MIB Access Mode
The access mode for MIB in all communities is read only. If you send a GET request for a SET
operation, you will receive NoSuchName as a GET RESPONSE.
Object Identifier System
An object system supported by SNMP agent is as follows:
Figure 15 Object System (1)
20 SNMP Supported MIB