HP StorageWorks XP SNMP Agent Reference Guide: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96056, May 2011)
Figure 11 Change Community dialog box
Adding Community IP Addresses
To add a community IP address:
1. Log on to Remote Web Console. Click Go – Environmental Settings – SNMP Information in the
menu bar of Remote Web Console Main window. The SNMP Information window is displayed
(see “SNMP Information Tab” (page 10)).
2. Select and right-click the desired community to display the Add Community pop-up menu (see
Figure 12 (page 17)).
3. Select Add IP Address. The Add IP Address dialog box displays (see Figure 13 (page 18)).
4. In IP Address, enter a new IP address or select an existing IP address.
5. Select OK. The new IP address displays in Community & Trap, but the change is not yet
implemented.
6. Select Apply. Select OK or Cancel.
Figure 12 Add IP Address Pop-Up Menu
Adding Community IP Addresses 17