HP StorageWorks XP SNMP Agent Reference Guide: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (AE002-96056, May 2011)

3. Select one or more unwanted IP addresses in IP Address list box. Right-click to display Delete
IP Address pop-up (see Figure 6 (page 14)).
4. Select Delete IP Address.
5. A confirmation message displays. Select OK or Cancel.
6. Select Apply. Select OK or Cancel.
Figure 6 Delete IP Address Pop-Up Menu
Adding a Community Name
To add a community name:
1. Change to Modify mode.
2. Log on to Remote Web Console. Click Go Environmental Settings SNMP Information in the
menu bar of Remote Web Console Main window. The SNMP Information window is displayed
(see “SNMP Information Tab (page 10)).
3. In Community &Trap box, select and right-click Community. Add Community pop-up menu
displays (see Figure 7 (page 15)).
4. Select Add Community. Community dialog box (see Figure 8 (page 15)) displays.
5. In the Community text box, enter desired community name. You can use up to 180
alphanumeric characters, except for ", \, ;, :, ,, *, ?, <, >, |, /, ^, &, and %. You can also
use spaces, except at the beginning or the end of the name.
6. Select OK. The new community name displays in Community & Trap, but the changes are not
yet implemented in the subsystem.
7. To add one or more IP addresses to the new community, see Adding Community IP Addresses.
8. To apply changes, select Apply. Select OK or Cancel.
14 Performing SNMP Operations