HP StorageWorks Disk Array XP operating system configuration guide: MPE/iX (A5951-96145, November, 2005)

Example

CSYLE18<PUB.SYS>:ioconfig

IOCONFIG A.0 0. 00 (catalog A.00.00)

ioconfig:ap path=0/6/0; id=pci_device

ioconfig:ap path=0/6/0/0; id=a6795a

td: claimed Ta ch

yon XL2 Fibre Channel Mass Stor age card

at 0/6/0/0

Scanning for f ibre channel devic es at 0/6/0/0. This ma y

take a while.. .

ioconfig: ex

keeping to gro up CONFIG.SYS

Purge old conf iguration (yes/no)?Automatic y es

** configura t

ion files succ essfully saved **

CSYLE18<PUB.SYS>:

3. Run the fcscan –h utility to obtain the I/O paths for the disk array N-ports and LUNs.

Example

CSYLE18<PU

B.SYS>:fcscan -h

FCSCAN Versi on 1.1

Scanning for F ibre Channel devic es.

This could tak e u pto few minutes. Ple ase wait ...

FCSCAN ha

s found the following Fibre Chann el I/O Adapter Cards

and Devices on this system.

SYSGEN P

ATH DESCRI PT ION BOOT MENU PATH

============= ============= ======= === ======

0/6/0/0

Fibre Channel A dapter

0/6/0/0.102 Fibre Channel N-Po rt

0/6/0/0.102.0 HP OPEN-3 dis k 0/6/0/0.8.0.102.0.0.0

0/6/0/0.102.1 HP OPEN-3 dis k 0/6/0/0.8.0.102.0.0.1

0/6/0/

0.102.2 HP OP EN-3 disk 0/6/0/0 .8.0.102.0.0.2

0/6/0/0.102.3 HP OPEN-3 dis k 0/6/0/0.8.0.102.0.0.3

……

CSYLE

18<PUB.SYS>:

4. Choose the disk array LUN that you will use as the new MPE/iX Ldev 1 and note

the BOOT MENU PATH I/O path for that disk in the fcscan output listing. That path

will become the system’s primary boot path. For this example, LUN 2 on the disk

array was used at BOOT MENU PATH 0/ 6/ 0/0 .8.0.102.0.0.2

5. Shut down the running system and reset (or TC) the computer.

Bootingfromthearray