HP StorageWorks Disk Array XP operating system configuration guide for Windows 2000/2003 XP24000, XP12000, XP10000, SVS200, v01 (A5951-96195, June 2007)

Figure 2 Point-to-point fabric topology example
Table 5 Fabric topology settings
ProvidesConnection parameterFabric parameter
NL-port (private arbitrated loop)FC-ALOFF
FL-port (public loop) for loop connection to a switchFC-ALON
N-port (fabric port) for connection to a switchPOINT-TO-POINTON
Not supportedPOINT-TO-POINTOFF
Installing and configuring the host
This section explains how to install and configure the host and host bus adapters (HBAs) that connect
the host to the disk array.
Loading the operating system and software
Follow the manufacturer's instructions to load the operating system and software onto the host. Load
all operating system patches and configuration utilities supported by HP and the HBA manufacturer.
If you purchased multipath software, install it according to the manufacturer's instructions.
Installing and configuring the HBAs
Install and configure the host bus adapters using the HBA manufacturer's instructions.
HP supplies driver, firmware, and BIOS downloads for commonly available HBAs. These downloads
contain HBA settings that are tested and approved by HP. To obtain a download, log onto the HP
website at www.hp.com and search for the model name or number of your HBA. Download the file,
and follow the installation instructions in the “readme” or documentation file supplied with each
download.
Contact your HP representative for current information on compatible HBAs.
XP Disk Array Configuration Guide for Windows 2000/2003 17