HP StorageWorks Disk Array XP operating system configuration guide for NonStop XP24000, XP12000, XP10000, XP1024, XP128, v01 (A5951 - 96222, June 2007)

In XP Remote Web Console and XP Command View, LUN mapping includes:
• Configuring ports
• Enabling LUN security on the ports
• Creating host groups
• Assigning host bus adapter WWNs to host groups
• Mapping volumes to host groups (by assigning LUNs)
In Command View XP Advanced Edition, LUN mapping includes:
• Configuring ports
• Creating storage groups
• Mapping volumes and WWN/host access permissions to the storage groups
For details, see HP StorageWorks XP LUN Manager User's Guide or Command View XP Advanced
Edition Device Manager Web Client User's Guide.
Record the LUNS and their ports, WWNs, nicknames, and LDEVs. This information will be used later
to verify host and device configuration.
Verifying disk array device recognition
For the NonStop host to recognize disk devices, the disk devices must first be configured and started
using the installation procedure described in chapter 2 of the Fibre Channel ServerNet Adapter
Installation and Support Guide available at the NonStop Technical Library web site:
http://h30163.www3.hp.com/ntl/.
Configuring disk devices
Configure the disk array devices in the same way you would configure any new disk on the host.
Creating scripts to configure all devices at once may save you considerable time.
Refer to Fibre Channel ServerNet Adapter Installation and Support Guide, at the NonStop Technical
Library web site:
http://h30163.www3.hp.com/ntl/.
Installing and configuring NonStop for the XP disk array18