HP Replication Adapter for VMware vCenter Site Recovery Manager Administrator Guide (5697-2491, February 2013)

%ALLUSERSPROFILE%\VMware\VMware vCenter Site Recovery Manager\Logs\vmware*.log
• Collect the outputs of the following command on HORCMINST=XX (instance# for SRA):
set
%HORCMROOT%\HORCM\etc\raidqry -l
%HORCMROOT%\HORCM\etc\raidqry -g
%HORCMROOT%\HORCM\etc\pairdisplay –IH –g ??? –CLI –l –fwe %HORCMROOT%\HORCM\etc\raidscan –IH –p
port(i.e. cl1-a-0) –CLI (port where connecting to ESX sever)
Where ??? is a group name shown by raidqry –g.
If BC is installed, enter the following command:
%HORCMROOT%\HORCM\etc\pairdisplay –g ??? –CLI –l –few –m cas
Where ??? is a group name shown by raidqry –g.
RMSRA20 remote configuration
On Windows where SRM is performing and on UNIX where RAID Manager is performing, execute
the following procedures:
• Collect the SRM log file on Windows from both the protection and recovery sites.
Collect the following SRM log file, including the error messages of [RMSRA20], SRM ERROR
messages, and the RAID Manager command error log by entering the following:
env
raidqry -l
raidqry -g
pairdisplay –IH –g ??? –CLI –l –fwe
raidscan –IH –p port(i.e. cl1-a-0) –CLI
Where ??? is a group name shown by raidqry –g and raidscan command specifies the
port connected to the ESX server.
If BC is installed, enter the following command:
pairdisplay –g ??? –CLI –l –few –m cas )
Where ??? is a group name shown by raidqry –g.
Collecting the information 49