HP Replication Adapter for VMware vCenter Site Recovery Manager Administrator Guide (5697-2491, February 2013)

• To connect to the RAID Manager on a remote UNIX Host, enter one of the following:

◦ HORCMINST=X@Host-name, which connects to HORCMINST=X on the Remote

UNIX Host.

◦ $HORCMINST@Host-name, which connects the $HORCMINST setting to the Remote

NOTE: If the array is set as the authentication mode, the remote user must have

completed the authentication for its array.

If no root user is needed for the use of Telnet, you must have permission to use the RAID

Manager commands.

If the remote host is SUSE Linux, which does not recognize network as a terminal type,

you must set the following variables:

setx RMSRA_TEL_WAITS "/terminal type\? /i" /m

setx RMSRA_TEL_RESPS vt100 /m

4. For an RMSRA20 configuration using local connection, enter the HORCM instance to connect

to RAID Manager instance via RMSRA20. specifying the following formats (see Figure 21 (page

33)):

32 Configuring SRM and P9000 (XP) disk array