HP Replication Adapter for VMware vCenter Site Recovery Manager Administrator Guide (5697-2491, February 2013)

2 Installation procedure
The HP9000 SRA Software provides the files shown in “RMSRA20 files” (page 23).
Table 4 RMSRA20 files
Installation filesFile nameTitleNo.
DIR\command.plRMXPSRA.exeRMSRA20001
DIR\rmsra20.exe
DIR\rmsra20.linux
DIR\rmsra20.solaris
DIR\rmsra20.xsolaris
DIR\rmsra20.hp
DIR\rmsra20.aix
NOTE: DIR is <SRM install directory>\storage\sra\RMXP. The <SRM install
directory> is shown by HKEY_LOCAL_MACHINE\SOFTWARE\VMware, Inc.\VMware
vCenter Site Recovery Manager\InstallPath, such as C:\Program Files (x86)\
VMware\VMware vCenter Site Recovery Manager.
If the <SRM install directory> does not exist, C:\Program Files\VMware\VMware
vCenter Site Recovery Manager is the default.
Procedure for new introduction
You must install this product at both the local site SRM server (protected site) and the remote site
SRM server (recovery site). You must confirm that the VMware Site Recovery Manager Service is
enabled as a service You must also confirm the services in Table 1 (page 6) by using
Adminstrative Tool > Services as shown in Figure 14 (page 23).
Figure 14 Display example
To install the software:
1. Download the rmhtcsra.exe file from the VMware web site, and save it in a temporary
folder.
2. Executes rmhtcsra.exe.
3. Restart the VMware Site Recovery Manager Service by entering the following commands:
Procedure for new introduction 23