HP StorageWorks XP10000 Disk Array Owner's Guide (AE102-96013, March 2008)

DescriptionIndicatorLabelItem
During normal operation, this LED should be off.
ON: A service information message (SIM) has
been issued from either storage cluster. If the disk
array is set up for remote support, your HP support
representative is notified automatically. If the disk
array is not set up with remote support, place a
service call to HP to have the message evaluated
to determine if any action is required.
BLINKING: An SVP failure has occurred. The disk
array will continue to operate normally. Place a
service call to HP to ensure notification. SVP
failures might not be reported automatically to
STC.
LED (Amber)MESSAGE3
If a blocked path occurs between a host and a
disk drive, this switch is used to unfence the
fenced drive path and to release Write Inhibit.
During normal operation, this switch should be in
the upper position. Restarting the array performs
a soft reset to try to recover. If the system restart
does not unblock the path, an HP support
representative will be notified.
CAUTION:
Do not change the switch position unless
directed to do so by HP service personnel.
SwitchRESTART4
During normal operation, this LED may be on if
remote maintenance is occurring. Remote
maintenance can occur and this LED can light
only when the REMOTE MAINTENANCE
ENABLE/DISABLE switch is in the ENABLE
position.
ON: Remote maintenance is in progress. An HP
support representative is probably working on the
system. The system remains online and accepting
data.
LED (Amber)
REMOTE MAINTENANCE
PROCESSING
5
Used to permit remote service maintenance.
During normal operation, this switch should be in
the ENABLE position.
DISABLE: No one can provide remote
maintenance.
ENABLE: An HP support representative can
provide remote maintenance.
CAUTION:
Do not change the switch position unless
directed to do so by HP service personnel.
Switch
REMOTE MAINTENANCE
ENABLE/DISABLE
6
XP10000 Disk Array Owner's Guide 23