HP StorageWorks XP10000 Disk Array Owner's Guide (AE102-96013, March 2008)

Figure 2 HP XP10000 control panel components
Table 3 HP XP10000 control panel components
DescriptionIndicatorLabelItem
During normal operation, this LED should be on.
ON: Input/output on the channel interface is
enabled.
OFF: The system is not accepting data.
LED (Green)READY1
During normal operation, this LED should be off.
ON: One or more of the following:
The DC is under voltage.
The DC is over current.
The temperature is abnormally high.
An unrecoverable failure has occurred.
If the disk array is set up with remote support;
your HP support representative is notified
automatically. If the disk array is not set up with
remote support, place a service call to HP to have
the message evaluated to determine if any action
is required.
BLINKING: The DC is under voltage.
LED (Red)ALARM2
HP XP10000 hardware components22