HP XP7 P9000 Remote Web Console Messages

Table 28 Error codes (part code 01005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the setting(s), then retry the operation.When requesting a configuration change
of LUN-Security, a nickname is not
00111101005
specified. Specify the nickname of HOST
GROUP.
WCheck the setting(s), then retry the operation.When registering WWN, the value is
not specified. Or, zero is set as the value
00111601005
of WWN. Be sure to set the WWN
value before requesting the configuration
change.
WThe configuration information has been changed
already. Check the settings, and request the
configuration information setting again.
Command device security cannot be set
to the specified volume because the
volume is not a command device.
00112301005
WThe configuration information has been changed
already. Check the settings, and request the
configuration information setting again.
There are no host groups where the
WWN will be registered.
00112501005
WCheck the setting(s), then retry the operation.An error occurred. If this problem
persists, please contact HP Technical
Support.
00112801005
WCorrect the specified contents, and request again.You cannot specify the default nickname
when setting the nickname of a host
group or a host.
00113001005
WNo more host groups can be set, because the
number of host groups has reached the maximum
No more host groups can be set,
because the number of host groups has
00113101005
(254) that can be set in a port. Reduce the
number of host groups, then retry the operation.
reached the maximum (254) that can be
set in a port.
WThe configuration information has been changed
already. Check the settings, and request the
configuration information setting again.
Failed to set the WWN because the
number of WWNs exceeds the
maximum that can be set in a port.
00113201005
WThe configuration information has been changed
already. Check the settings, and request the
configuration information setting again.
Failed to set the host mode because the
number of host modes exceeds the
maximum that can be set in a port.
00113301005
WThe configuration information has been changed
already. Check the settings, and request the
configuration information setting again.
Failed to set the path because the
number of paths exceeds the maximum
that can be set in a port.
00113401005
WCheck the setting(s), then retry the operation.When setting the port information (Fibre
Address/Fibre Topology/Channel
00113501005
Speed), multiple change instructions are
set to the same port.
WThe configuration information has been changed
already. Check the settings, and request the
configuration information setting again.
The same setting is specified at LUNM
operation.
00113801005
WRelease the Port Group setting.Because the Port Group setting is done,
it is impossible to change.
00114001005
WCorrect settings, then retry.The volume cannot be configured as a
command device because the volume
does not have Read/Write attribute.
00117001005
WCorrect the settings, then retry.The specified host ID is already
registered.
00117401005
WCorrect the settings, then retry.The specified host is already registered.00117701005
WCorrect the settings, then retry.An incorrect host name was specified.00117801005
Part code 01005 67