HP XP P9000 Remote Web Console Messages (AV400-96604, January 2014)

Table 54 Error codes (part code 06005) (continued)
Severity LevelRecommended ActionError MessageError
Number
Part
Code
use Continuous Access Synchronous, please
contact HP Technical Support.
WThe MCU NVS status specified by the host is not
active. Set the NVS to "on" for the MCU, using
any attached host, then retry the operation.
NVS status of MCU is not active.00873906005
WThe RCU NVS status specified by the host is not
active. Use any attached host to set the NVS to
"on" for the MCU, then retry the operation.
NVS status of RCU is not active.00874006005
WCheck the path status between the MCU and the
RCU.
The logical paths between the MCU and
RCU are not established.
00874106005
WCheck the status of the M-VOL tracks, and clear
the pinned tracks.
Pinned track(s) exists on the M-VOL.00874206005
WCheck the status of the R-VOL tracks, and clear
the pinned tracks.
Pinned track(s) exists on the R-VOL.00874306005
WThe M-VOL is not available for the requested
operation, because of one or more of the
following reasons:
The specified M-VOL condition is not
valid for Remote Copy.
00874406005
• The volume is blocked.
• The volume is under maintenance.
• The volume is copying data (correction copy
or drive copy).
• The volume is in the correction access
condition.
Check the logical device status of the specified
M-VOL. If the M-VOL is either under maintenance
or copying data, retry the operation after the
process is completed.
WSelect another volume.A volume cannot be used as an R-VOL
when:
00874506005
• it is used by Compatible XRC.
• it is used by PPRC or Remote Copy.
• it is used by Concurrent Copy.
• it is in a reserved condition.
• it is used by Continuous Access
Journal or Continuous Access Journal
Z.
• it is used by Business Copy Z or
Compatible FlashCopy.
WSee the INSTALLATION SECTION and
OPENPLATFORM SECTION in the maintenance
The device emulation type of the M-VOL
is not supported.
00874606005
manual to confirm whether the device emulation
type of the M-VOL is supported by Remote Copy.
WThe version of the microcode on the 9900 storage
system does not support the specified function or
operation. Please contact HP Technical Support.
Current microcode version does not
support the specified operation.
00874706005
WData migration cannot start because the volume
is online. Vary the path offline, and retry.
Specified M-VOL may be in use by
HOST.
00874806005
Part code 06005 161