HP XP P9000 Remote Web Console Messages (AV400-96604, January 2014)

Table 54 Error codes (part code 06005) (continued)
Severity LevelRecommended ActionError MessageError
Number
Part
Code
WReduce the number of RCUs, and then retry the
operation.
The operation failed because the number
of RCUs is in one of the following status:
00872006005
• Maximum 4 RCUs are already
registered in one CU.
• Maximum 64 RCUs are already
registered while CU FREE is selected.
WCheck the path connections between the MCU
and the RCU, then retry the operation.
Path not completely established.00872106005
WCheck the path connections between the MCU
and the RCU, then retry the operation.
Failure during path creation.00872206005
WAdd another path, or delete all pairs on the RCU.
Then retry the operation.
The Edit Path operation was rejected
because the specified path is the last
path of some Remote Copy pairs.
00872306005
WThe specified number of paths is less than the
minimum number of paths specified on the RCU
Option window.
Specified number of paths is less than
the minimum specified on RCU Option
screen.
00872406005
WThe version of the microcode on the 9900 storage
system does not support the specified function or
operation. Please contact HP Technical Support.
Current microcode version does not
support the specified operation.
00872506005
WAdd the normal path(s), then set the minimum
number of paths.
The number of minimum paths exceeds
the number of normal paths.
00872706005
WPlease take either of the following actions:The number of minimum paths exceeds
the number of normal paths.
00872806005
Add normal paths, then delete the paths.
Decrease the number of minimum paths, then
delete the paths.
EIf this problem persists, please contact HP
Technical Support.
An internal error occurred.00872906005
WIf you are adding RCUs, specify the same logical
address.
Invalid Logical Addresses are specified.00873006005
If you are editing paths, specify the same logical
address as the existing paths. (See the Edit Path
dialog box.)
WThe logical addresses of all existing paths are not
the same. Delete the RCU, then re-add it, using
the same logical address as other existing paths.
The existing logical addresses are not
equal.
00873106005
WThe maximum number of SSIDs (four) has been
entered. Verify that the SSIDs are valid, delete
one or more, then retry the operation.
Too many SSIDs. (Only Four SSIDs are
allowed).
00873206005
WCheck the serial number, SSID and link address
of the RCU, and set the correct value. Then retry
Invalid RCU serial number, SSID, Link
Address or Controller ID.
00873506005
the operation. If the same error occurs, please
contact HP Technical Support.
WDelete all Remote Copy volume pairs of the
specified RCU or SSID, and retry the operation.
The specified RCU or SSID contains
some Remote Copy volume pairs.
00873606005
EIf this problem persists, please contact HP
Technical Support.
An internal error occurred.00873706005
WThe emulation type of the MCU does not support
Continuous Access Synchronous. If you want to
Remote Copy is not supported under the
MCU Controller emulation type.
00873806005
160 Messages (part code group 06nnn)