HP XP P9000 Remote Web Console Messages (AV400-96604, January 2014)

Table 54 Error codes (part code 06005) (continued)
Severity LevelRecommended ActionError MessageError
Number
Part
Code
WCheck the paths status and reestablish the paths.The specified number of paths is less
than the minimum number of paths on
00870406005
the RCU option screen due to a
communication error between the MCU
and the RCU.
WEither a communication error occurred between
the MCU and the RCU, or the CHA has become
blocked. Please contact HP Technical Support.
The path could not be deleted due to a
communication error between MCU and
RCU.
00870506005
WSpecify a correct value.Parameter specified by Remote Copy
operation is invalid.
00870606005
WCheck the pair status for Continuous Access
Synchronous. If the requested R-VOL is in a
permissible status, please retry the operation.
The pair status of the R-VOL is not valid.00870806005
EAll channel adapters are not active for Continuous
Access Synchronous. Please contact HP Technical
Support.
Remote Copy operation was rejected.00870906005
WThe pair status does not permit this operation.
Verify the pair status, and if the operation is
permitted retry.
The pair status of the specified volume
is not valid.
00871006005
WCheck if the specified Port, GID, LUN, CU, or
LDEV number exists in the storage system.
The Port, GID, LUN, CU, or LDEV
number of the specified volume is
incorrect.
00871106005
WIf this was a path operation retry after the problem
has been fixed.
The operation was rejected due to a
'FREEZE' state.
00871206005
If this was a pair operation, retry after the paths
have been recovered. Two ways to recover paths
are:
(a) Execute ESTPATH from the host console, or
(b) First delete the path(s) from the SVP, then
re-add them.
WThe port type could not be changed because the
port group was set in the specified package.
The port group already exists on the
specified port.
00871306005
Delete the group setting, then change the port
type.
EIf this problem persists, please contact HP
Technical Support.
An internal error occurred.00871406005
WThe specified number of paths is not within the
acceptable path range of 0 to 4. Verify the
number of paths and retry the operation.
Invalid number of paths.00871506005
WThe specified logical address must be either 00
or 01. Check the logical address and retry the
operation.
Invalid Destination Link Address.00871706005
WCheck all existing logical path addresses, and
specify another link address or port.
The specified logical path already exists.00871806005
WCheck the serial number, SSID, link address and
controller ID of the RCU, and set the correct value.
Invalid RCU serial number, SSID, Link
Address or Controller ID.
00871906005
Then retry the operation. If the same error occurs,
please contact HP Technical Support.
Part code 06005 159