HP P9000 Remote Web Console Messages (AV400-96401, October 2011)

Table 27 Error codes (part code 1005) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WSet Host Mode Option 60 to OFF, and
then execute addition or deletion of
paths for LUN 0.
Addition or deletion of paths for LUN0
cannot be done because Host Mode
Option 60 is set to ON. Also, setting
19281005
change of Host Mode Option 60 and
path change (addition or deletion) for
LUN 0 cannot be done at the same time.
Execute the changing operations
separately.
WPlease contact HP Technical Support.Releasing the Host Mode Option 61 is
disabled.
19291005
WIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
20051005
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
20091005
WRecovery processing may take about 1
minute. Wait for a while.
The LDEV is being used by the host, or
an error occurred in the SVP procedure.
20101005
WIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
20131005
WIf the same error occurs despite retrying,
please contact HP Technical Support.
An error occurred while connecting to
the storage system.
20151005
WIf the same error occurs despite retrying,
please contact HP Technical Support.
An error occurred while connecting to
the storage system.
20321005
WUnmount the host and cancel reservation
of the device. If the host is an AIX host,
Processing is disabled because the host
is mounted or the device is reserved.
20821005
unmount the host, and execute the
varyoffvg command.
WCheck the DKC status and the current
status of the configuration setting. If
The subsystem status is invalid.20831005
necessary, re-execute the setting
operation.
WCheck the DKC status and the current
status of the configuration setting. If
The subsystem status is invalid.20841005
necessary, re-execute the setting
operation.
WCheck the settings, then retry the
operation.
The host specified by the WWN is
performing I/O operations.
20971005
EWhen the same problem persists, please
contact HP Technical Support.
The operation cannot be performed,
because the SVP microcode version does
20981005
not match the DKCMAIN (subsystem)
microcode version.
WWait a while, then retry the operation.
If the same problem persists. Please
contact HP Technical Support.
The operation cannot be performed,
because an inoperative Processor exists.
20991005
WClick [Refresh All] on the [File] menu,
then refresh the configuration. If the same
An error occurred while connecting to
the storage system. The configuration
may be inconsistent.
21001005
problem persists despite retrying, please
contact HP Technical Support.
WCorrect the settings, then retry.The volume cannot be configured as a
command device because the volume
does not have Read/Write attribute.
25011005
Part code 1005 67