HP P9000 Remote Web Console Messages (AV400-96401, October 2011)

3 Message (part code group 1nnn)
This chapter includes the error messages with the part code 1005 to 1310.
Part code 1005
Table 27 Error codes (part code 1005)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WSelect another volume.The specified volume cannot be set as a
command device or a component of a
10021005
LUSE volume, because it is being used
as the volume of Remote Copy, Business
Copy, Auto LUN, or Snapshot.
WThe configuration information has been
already changed.
You are trying to set multiple paths to the
same volume from one group.
10031005
Check the settings, and request the
setting of the configuration information
again.
WThe configuration information has been
already changed.
Multiple volumes are specified to a single
port, group or LUN combination.
10041005
Check the settings, and request the
setting of the configuration information
again.
WCheck the settings, then retry the
operation.
The following volumes cannot be
specified when you change the path
configurations:
10051005
• Volumes that do not exist
• Volumes other than the top LUs in
expanded LUs
• Volumes reserved by Auto LUN
• System Disk volume
WCheck the setting.Failed to remove the path. The specified
path is the last path of the volumes used
10071005
for Remote Copy, Business Copy, Auto
LUN, or Snapshot.
WThe configuration information has been
changed already. Check the settings,
The emulation type of the volumes is not
for open systems, or the volumes are not
mounted.
10091005
and request the setting of the
configuration information again.
WIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
10101005
WThe configuration information has been
changed already. Check the settings,
The specified port does not exist. Or the
specified port type is not Fibre port.
10181005
and request the configuration information
setting again.
WThe configuration information has been
changed already. Check the settings,
Invalid LUN.10201005
and request the configuration information
setting again.
WThe configuration information has been
changed already. Check the settings,
Invalid host mode.10211005
62 Message (part code group 1nnn)