HP P9000 Remote Web Console Messages (AV400-96401, October 2011)

Table 68 Error codes (part code 8105) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WCheck the setting.The path cannot be set to the specified
volume, because the volume is being
used as a quorum disk.
19268105
WCheck the setting.The specified volume cannot be set as a
command device, because it is being
used as a quorum disk.
19278105
WSet Host Mode Option 60 to OFF, and
then execute addition or deletion of
paths for LUN0.
Addition or deletion of paths for LUN0
cannot be done because Host Mode
Option 60 is set to ON. Also, setting
19288105
change of Host Mode Option 60 and
path change (addition or deletion) for
LUN0 cannot be done at the same time.
Execute the changing operations
separately.
WPlease contact HP Technical Support.Releasing the Host Mode Option 61 is
disabled.
19298105
EUse the SVP to check if the DKC is in the
normal status, then retry. If the same
An error occurred during SVP
processing.
20038105
problem persists despite retrying, please
contact HP Technical Support.
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
20058105
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
20098105
WRecovery processing may take about 1
minute. Wait for a while.
The LDEV is being used by the host, or
an error occurred in the SVP procedure.
20108105
EPlease contact HP Technical Support.The status of the storage system requires
maintenance (for example, the storage
20118105
system is blocked, the shared memory is
inconsistent, or some other factor).
EIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
20138105
WIf the same error occurs despite retrying,
please contact HP Technical Support.
An error occurred while connecting to
the storage system.
20158105
EUnmount the host and cancel reservation
of the device. If the host is an AIX host,
Processing is disabled because the host
is mounted or the device is reserved.
20828105
unmount the host, and execute the
varyoffvg command.
WCheck the DKC status and the current
status of the configuration setting. If
The subsystem status is invalid.20838105
necessary, re-execute the setting
operation.
WCheck the DKC status and the current
status of the configuration setting. If
The subsystem status is invalid.20848105
necessary, re-execute the setting
operation.
WCheck the settings, then retry the
operation.
The host specified by the WWN is
performing I/O operations.
20978105
WDelete or suspend all pairs to which the
journal volumes belong.
Devices to be maintained include journal
volumes.
22048105
288 Message (part code group 8nnn)