HP P9000 Remote Web Console Messages (AV400-96401, October 2011)

Table 68 Error codes (part code 8105) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WThe configuration information has been
changed already. Check the settings,
You are trying to register the same host
group as the existing one.
10678105
and request the configuration information
setting again.
WThe configuration information has been
changed already. Check the settings,
The specified host group has not been
registered.
10688105
and request the configuration information
setting again.
WCheck the setting, then retry the
operation.
The following volumes cannot be
specified when you change the
command device configurations:
11088105
• Volumes reserved by Auto LUN
• Volumes other than the open-system
volumes (including unmounted
volumes)
• System Disk volume
WRemove the prohibited characters from
the nickname.
You cannot use following characters for
the name:
11108105
" \ / : , ; * ? < > |
You cannot use spaces for the first and
the last characters in the name.
WCheck the setting(s), then retry the
operation.
When requesting a configuration change
of LUN-Security, a nickname is not
11118105
specified. Specify the nickname of HOST
GROUP.
WCheck the setting(s), then retry the
operation.
When registering WWN, the value is
not specified. Or, zero is set as the value
11168105
of WWN. Be sure to set the WWN
value before requesting the configuration
change.
WThe configuration information has been
changed already. Check the settings,
Command device security cannot be set
to the specified volume because the
volume is not a command device.
11238105
and request the configuration information
setting again.
WThe setting method of command
device/command device security is
An error occurred. If this problem
persists, please contact HP Technical
Support.
11248105
incorrect. The following settings are
The command device setting and the
command device security setting are
invalid. *Set command device + Release
command device security
*Release command device + Set
command device security
incorrect. You cannot do any of the
following to the same volume:
• Specify the volume as a command
device and disable command device
security on the volume.
The error does not occur normally
because it cannot be modified in the
window. In the unlikely event that this
error occurs, please contact HP Technical
Support.
• Specify the volume as a
non-command device and enable
command device security on the
volume.
WThe configuration information has been
changed already. Check the settings,
There are no host groups where the
WWN will be registered.
11258105
and request the configuration information
setting again.
Part code 8105 285