HP P9000 Remote Web Console Messages (AV400-96401, October 2011)

Table 68 Error codes (part code 8105) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
for Remote Copy, Business Copy, Auto
LUN, or Snapshot.
WThe configuration information has been
changed already. Check the settings,
The emulation type of the volumes is not
for open systems, or the volumes are not
mounted.
10098105
and request the configuration information
setting again.
WIf this problem persists, please contact
HP Technical Support.
An error occurred during SVP
processing.
10108105
WThe configuration information has been
changed already. Check the settings,
The specified port does not exist. Or the
specified port type is not Fibre port.
10188105
and request the configuration information
setting again.
WThe configuration information has been
changed already. Check the settings,
Invalid host mode.10228105
and request the configuration information
setting again.
WCorrect the specified content, and issue
the request again. (Currently, Bad Value
Send report in Set Response.)
The specified fiber address is wrong.10238105
WThe configuration information has been
changed already. Check the settings,
Invalid Fibre topology information.10248105
and request the configuration information
setting again.
WThe configuration information has been
changed already. Check the settings,
The specified LU path does not exist.10258105
and request the configuration information
setting again
WCheck the specified contents, then retry
the operation.
LUN security setting has been made to
a non-Fibre port. LUN security is a
function of LUN Manager.
10598105
WYou are trying to perform LUN Security
operation for a port where LUN Security
Security Switch Off operation and path
adding operation cannot be performed
simultaneously.
10618105
function is invalid. The error does not
occur normally because it cannot be
modified in the window. In the unlikely
event that this error occurs, please
contact HP Technical Support.
WCheck the specified contents, then retry
the operation.
The specified WWN is already in use.10638105
WThe configuration information has been
changed already. Check the settings,
You are trying to register the same
WWN that is already registered.
10648105
and request the configuration information
setting again.
WCorrect the specified contents, and
request the setting of the configuration
information again.
The specified host name or the host
group name is already registered. (The
host name and the host group name
cannot be the same.)
10658105
WThe configuration information has been
changed already. Check the settings,
WWN number, which is not registered,
is specified. (When deleting, or
changing.)
10668105
and request the configuration information
setting again.
284 Message (part code group 8nnn)