HP P9000 Remote Web Console Messages (AV400-96401, October 2011)

Table 59 Error codes (part code 6610) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WClick [OK]. Apply the preview data to
the storage system, then retry the
operation.
Since the number of preview data
exceeded the maximum, the excess data
were discarded. No more preview data
can be stored.
590096610
iCheck the contents of the primary and
secondary volumes. If the contents match,
click [Yes]. Otherwise, click [No].
WARNING:
Initial copy mode "None" is selected for
some volume pair. Are you sure that the
590106610
primary data volume and the secondary
data volume of the pair are already
synchronized?
iTo output the file, click [Yes]. Otherwise,
click [No].
Are you sure you want to output the %s
file?
590116610
WTo overwrite the file, click [Yes].
Otherwise, click [No].
The specified file already exists. Do you
want to overwrite this file?
590136610
WCheck the paramaters of the DKC setting.The same DKC is specified more than
once. Check the DKC setting.
590266610
WTo continue the operation, click [OK]. To
cancel the operation, click [Cancel].
The monitoring data saved at present
will be deleted.
590306610
The current monitoring data will be
deleted if you change the setting of the
monitoring switch. If necessary, use the
Performance Monitor Export Tool to
export the monitoring data file.
iTo continue processing, click [OK]. To
stop processing, click [Cancel].
The monitoring data being saved at
present is deleted when the monitoring
switch is set to Enable at the next time.
590316610
If the currently saved monitoring data is
needed, use the export tool to save the
data.
WPurchase a license for Continuous Access
Journal Z, then install it.
You cannot add journal volumes because
Continuous Access Journal Z is not
installed.
590406610
WTo delete the journal volume, click [Yes].
Otherwise, click [No].
Warning:
A mainframe volume is included in the
journal volumes to be deleted.
590416610
HP recommends that you record the
LDKC number, the CU number and the
LDEV number of the mainframe volume.
Note the following points if you have
made volume pairs by using this journal
before.
• The mainframe volume will be
blocked.
• The mainframe volume needs to be
formatted when you use the volume
as a non-journal volume.
• The LDKC number, the CU number
and the LDEV number of the
mainframe volumes are recommended
to be recorded.
Do you want to continue the operation?
WAll journals are used by Continuous
Access Journal Z or Continuous Access
There are no valid journals.590426610
Journal. If possible, delete the journals
for Continuous Access Journal Z or
Part code 6610 237