HP P9000 Remote Web Console Messages (AV400-96401, October 2011)

Table 56 Error codes (part code 6505) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WDo either of the following to recover from
the error:
The number of minimum paths exceeds
the number of normal paths.
87276505
• If the error code is 100c, add normal
paths, then set the minimum number
of paths.
• If the error code is 100d, add normal
paths, then delete paths. Alternatively,
reduce the minimum number of paths,
then delete paths.
WDo either of the following to recover from
the error:
The number of minimum paths exceeds
the number of normal paths.
87286505
• If the error code is 100c, add normal
paths, then set the minimum number
of paths.
• If the error code is 100d, add normal
paths, then delete paths. Alternatively,
reduce the minimum number of paths,
then delete paths.
ECheck the SSB log, then contact HP
Technical Support.
An internal error occurred.87296505
WDo either of the following to recover from
the error:
The specified logical address is incorrect.87306505
• If you are adding DKCs, specify the
same logical address.
• If you are editing paths, specify the
same logical address as the existing
paths.
WDelete the DKC once, then add the DKC
using the same logical address.
The existing logical addresses are not
the same.
87316505
WContinuous Access Journal or Continuous
Access Journal Z must be installed in the
Continuous Access Journal or Continuous
Access Journal Z is not installed in the
storage system.
87336505
storage system when you create a path
or a pair for Continuous Access Journal
or Continuous Access Journal Z. Install
Continuous Access Journal or Continuous
Access Journal Z in the storage system.
WContinuous Access Journal or Continuous
Access Journal Z must be installed in the
Continuous Access Journal or Continuous
Access Journal Z is not installed in the
remote storage system.
87346505
remote storage system when you create
a path or a pair for Continuous Access
Journal or Continuous Access Journal Z.
Install Continuous Access Journal or
Continuous Access Journal Z in the
remote storage system.
WCheck the serial number and the
controller ID of this remote storage
The serial number or the controller ID of
the remote subsystem is incorrect.
87356505
system and already registered remote
storage systems, then specify the correct
values.
If the specified values are correct, check
the cable connection of the remote
storage system. If the problem persists,
please contact HP Technical Support.
190 Message (part code group 6nnn)