HP P9000 Remote Web Console Messages (AV400-96401, October 2011)

Table 56 Error codes (part code 6505) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
EIf the same error occurs despite retrying,
please contact HP Technical Support.
An error occurred during SVP
processing.
70606505
EIf the same error occurs despite retrying,
please contact HP Technical Support.
An error occurred during SVP
processing.
71116505
EIf the same error occurs despite retrying,
please contact HP Technical Support.
This error code is not registered.73106505
ERetry the operation. If this problem
persists, please contact HP Technical
Support.
An error occurred during SVP
processing.
80006505
WWait a while, then retry the operation.A communication time-out error occurred
in the subsystem. Please wait for a while,
and then retry the operation.
80016505
WWait a while, then retry the operation.A communication time-out error occurred
in the subsystem. Please wait for a while,
and then retry the operation.
80026505
ERetry the operation. If this problem
persists, please contact HP Technical
Support.
An error occurred during SVP
processing.
81006505
ECheck whether the DKCMAIN microcode
version and the SVP microcode version
are mismatched.
This function is not supported.81026505
WRetry the operation.Please retry operation.87006505
WCheck the path status and edit the path
again.
The logical path between the local and
the remote subsystems is invalid.
87016505
WRefresh and check the window. If
possible, retry the operation on the
primary data volume.
The status of the primary data volume is
not valid.
87026505
WCheck the number of paths.The specified number of paths is less
than the minimum number of paths in the
DKC Option window.
87036505
WVerify that the secondary data volume is
not blocked, the restore journal is
The specified number of paths is less
than the minimum number of paths in the
87046505
registered, or the journal volumes of the
restore journal are not blocked.
DKC Option window, due to a
communication error between the local
and the remote storage systems.
The operation failed due to one of the
following reasons.
• The secondary data volume was
blocked.
• The restore journal was not
registered.
• The journal volumes of the restore
journal were blocked.
ECheck the CHA status on the window. If
the CHA is blocked, replace the CHA,
then retry the operation.
The path could not be deleted due to a
communication error between the local
and the remote subsystems.
87056505
WEnter the correct data.Parameter specified by Remote Copy
operation is invalid.
87066505
188 Message (part code group 6nnn)