HP P9000 Remote Web Console Messages (AV400-96401, October 2011)

Table 55 Error codes (part code 6010) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WClick [Refresh], and retry.The system cannot apply the new
configuration. Do you want to refresh?
81016010
WClick [Yes] to recover from the error
condition. If not, click [No].
An error occurred when copying started.
Do you want to recover from the error
condition?
89286010
If the recovery fails despite retrying,
suspend the corresponding pair
temporarily, and execute Resume Pair
(Pairresync) operation.
iFollow the instructions in the message.Exchange the channel cable connections
after confirmation of the port type.
90066010
iConfirm that the R-VOLs to specify are
varied off-line.
Please confirm that the R-VOLs to specify
are varied off-line.
90076010
iClick [OK].SIMs of Remote Copy are cleared.90086010
iClick [OK].The export is complete.90096010
iClick [Yes] to continue processing. After
processing is complete, reset the port
that is not in operation.
The Port Setting process has not
completed. Do you want to continue for
other ports?
90216010
iCheck the contents of the main and
remote volumes. If the contents match,
click [OK]. If not, click [Cancel].
WARNING: Initial copy mode 'None'
is selected for some volume pairs. Are
you sure that the M-VOL and the R-VOL
of these pairs are already synchronized?
90226010
iFollow the instructions in the message.Are you sure you want to exchange the
specified ports? Please confirm the
associated channel paths are off-line.
90246010
iTo continue the operation, click [OK].
Otherwise, click [Cancel].
Are you sure you want to switch the
ports? If the remote copy paths exist on
the ports, delete them beforehand.
90256010
iTo continue the operation, click [OK].
Otherwise, click [Cancel].
Are you sure you want to switch the
ports? If any remote copy paths exist on
90266010
the ports, delete them beforehand. Also,
to avoid the switching operation from
being reported as a failure, confirm first
that a message prompting you to change
the channel cable connections is
displayed, and then perform the
necessary changes.
WTo delete the specified RCU, click [OK].
Otherwise, click [Cancel].
Are you sure you want to delete the
specified RCUs?
90706010
WTo delete the specified path, click [OK].
Otherwise, click [Cancel].
Are you sure you want to delete the
paths of a specified RCU?
90716010
WTo delete the specified pair, click [OK].
Otherwise, click [Cancel].
Are you sure you want to delete the
specified volume pairs?
90726010
iTo suspend the specified pair, click [OK].
Otherwise, click [Cancel].
Are you sure you want to suspend the
specified volume pairs?
90736010
WTo delete the specified SSID, click [OK].
Otherwise, click [Cancel].
Are you sure you want to delete the
SSIDs of a specified RCU?
90756010
iTo close the window, click [OK].
Otherwise, click [Cancel].
Do you want to exit?91006010
iTo cancel, click [OK].Do you want to cancel?91016010
Part code 6010 181