HP P9000 Remote Web Console Messages (AV400-96401, October 2011)

Table 53 Error codes (part code 6005) (continued)
Severity LevelRecommended ActionError MessageError
Number
Part
Code
minutes later, refresh the
window, confirm if the
specified volumes are in the
permissible status, then retry
the operation.
WThe specified volume is not
part of a Continuous Access
Specified volume is not part of Remote
Copy pair (Not in Duplex(PAIR),
Pending(COPY), Suspend(PSUS) state).
88496005
Synchronous pair. Check the
volume.
WCheck the serial number,
SSID, link address and
Invalid RCU serial number, SSID, Link
Address or Controller ID.
88506005
controller ID of the RCU, and
set the correct value. Then
retry the operation. If the
same error occurs, please
contact HP Technical
Support.
WRefresh the window, and
check whether the specified
volume is a R-VOL.
The specified volume is not a R-VOL.88516005
WConfirm the R-VOL status.R-VOL status change failed after M-VOL
status change. Confirm R-VOL status.
88526005
WThe operation failed,
because of one of the
following reasons:
Delete Pair(Pairsplit-S) operation failed
because M-VOL is in Simplex(SMPL)
status.
88546005
• The specified volume is
simplex.
• There is no duplex,
duplex-pending, or
suspend volume in the
group.
Verify the volume status, and
retry the operation.
WThe operation failed,
because of one of the
following reasons:
Delete(Pairsplit-S) operation failed
because specified volume or other
volume in the same group is in status
transition.
88556005
• The status of the specified
volume or another
volume in the same group
is Deleting.
• The status of the specified
volume or another
volume in the same group
is Suspending.
Wait for the transition of
status to complete, then retry
the operation.
If the transition of status does
not occur, delete the volume
by using the "Force" mode
or the "Delete pair by force"
option.
EPlease contact HP Technical
Support.
An internal error occurred.88606005
164 Message (part code group 6nnn)