HP P9000 Remote Web Console Messages (AV400-96401, October 2011)

Table 53 Error codes (part code 6005) (continued)
Severity LevelRecommended ActionError MessageError
Number
Part
Code
occurs, please contact HP
Technical Support.
WDelete all Remote Copy
volume pairs of the specified
The specified RCU or SSID contains
some Remote Copy volume pairs.
87366005
RCU or SSID, and retry the
operation.
EPlease contact HP Technical
Support.
An internal error occurred.87376005
WThe emulation type of the
MCU does not support
Remote Copy is not supported under
the MCU Controller emulation type.
87386005
Continuous Access
Synchronous. If you want to
use Continuous Access
Synchronous, please contact
HP Technical Support.
WThe MCU NVS status
specified by the host is not
NVS status of MCU is not active.87396005
active. Set the NVS to “on”
for the MCU, using any
attached host, then retry the
operation.
WThe RCU NVS status
specified by the host is not
NVS status of RCU is not active.87406005
active. Use any attached
host to set the NVS to “on”
for the MCU, then retry the
operation.
WCheck the path status
between the MCU and the
RCU.
The logical paths between the MCU
and RCU are not established.
87416005
WCheck the status of the
M-VOL tracks, and clear the
pinned tracks.
Pinned track(s) exists on the M-VOL.87426005
WCheck the status of the
R-VOL tracks, and clear the
pinned tracks.
Pinned track(s) exists on the R-VOL.87436005
WThe M-VOL is not available
for the requested operation,
The specified M-VOL condition is not
valid for Remote Copy.
87446005
because of one or more of
the following reasons:
• The volume is blocked.
• The volume is under
maintenance.
• The volume is copying
data (correction copy or
drive copy).
• The volume is in the
correction access
condition.
Check the logical device
status of the specified
M-VOL. If the M-VOL is
either under maintenance or
Part code 6005 155