HP P9000 Remote Web Console Messages (AV400-96401, October 2011)

Table 53 Error codes (part code 6005) (continued)
Severity LevelRecommended ActionError MessageError
Number
Part
Code
been recovered. Two ways
to recover paths are:
(a) Execute ESTPATH from
the host console, or
(b) First delete the path(s)
from the SVP, then re-add
them.
WThe port type could not be
changed because the port
The port group already exists on the
specified port.
87136005
group was set in the
specified package. Delete
the group setting, then
change the port type.
EPlease contact HP Technical
Support.
An internal error occurred.87146005
WThe specified number of
paths is not within the
Invalid number of paths.87156005
acceptable path range of 0
to 4. Verify the number of
paths and retry the
operation.
WThe specified logical
address must be either 00
Invalid Destination Link Address.87176005
or 01. Check the logical
address and retry the
operation.
WCheck all existing logical
path addresses, and specify
another link address or port.
The specified logical path already
exists.
87186005
WCheck the serial number,
SSID, link address and
Invalid RCU serial number, SSID, Link
Address or Controller ID.
87196005
controller ID of the RCU, and
set the correct value. Then
retry the operation. If the
same error occurs, please
contact HP Technical
Support.
WA maximum of four RCUs
are permitted, and that
many already exist.
Too many RCUs. (Four RCUs are the
maximum.)
87206005
WCheck the path connections
between the MCU and the
Path not completely established.87216005
RCU, then retry the
operation.
WCheck the path connections
between the MCU and the
Failure during path creation.87226005
RCU, then retry the
operation.
WAdd another path, or delete
all pairs on the RCU. Then
retry the operation.
The Edit Path operation was rejected
because the specified path is the last
path of some Remote Copy pairs.
87236005
Part code 6005 153