HP P9000 Remote Web Console Messages (AV400-96401, October 2011)

Table 48 Error codes (part code 5205) (continued)
Severity
Level
Recommended ActionError MessageError
Number
Part
Code
WRetry the same operation. If nothing
changes, please contact HP Technical
Support.
Auto LUN does not support the volume(s).12095205
WInstall the shared memory if it is possible.The shared memory to set a plan is
insufficient.
12105205
If it is impossible to install the shared
memory, the plan cannot be set any
further.
See the section about the computational
methods of the number of movement
plans described in the HP P9000 Auto
LUN User Guide for the relation between
the number of plans that can be made
and the shared memory.
WRetry the same operation. If nothing
changes, please contact HP Technical
Support.
The number of volume pairs exceeds the
maximum.
12115205
WRetry the same operation. If nothing
changes, please contact HP Technical
Support.
The source volume(s) is not equipped.12125205
WRecover the blocked volume, then retry
the operation. Also, the system disk
The command was rejected due to one
of the following reasons.
12135205
cannot be used as P-VOL. Specify
another volume.
• The volume specified as a migration
source was blocked.
• The volume specified as a migration
source was used as a system disk.
WRetry the operation after the format is
completed.
The volume specified as a migration
source is being formatted.
12145205
WThe command device cannot be used for
Auto LUN. Specify another volume.
The volume specified as a migration
source is a command device.
12155205
WRetry the same operation. If nothing
changes, please contact HP Technical
Support.
The target volume(s) is not equipped.12165205
WRecover the blocked volume, then retry
the operation. Also, the system disk
The command was rejected due to one
of the following reasons.
12175205
cannot be used as P-VOL. Specify
another volume.
• The volume specified as a migration
target was blocked.
• The volume specified as a migration
target was used as a system disk.
WRetry the operation after the format is
completed.
The volume specified as a migration
target is being formatted.
12185205
WThe command device cannot be used for
Auto LUN. Specify another volume.
The volume specified as a migration
target is a command device.
12195205
WRetry the same operation. If nothing
changes, please contact HP Technical
Support.
The volume is not a reserved volume.12205205
WRetry the same operation. If nothing
changes, please contact HP Technical
Support.
The volume(s) are already used by Auto
LUN.
12215205
130 Message (part code group 5nnn)