HP P9000 RAID Manager User Guide
Table 80 SSB codes that are returned by raidcom add rcu command (continued)
raidcom add rcu
DescriptionError codeExecuting/
Asynchronous
Error message
SSB2SSB1
Failed to establish a path or the deletion operation. The following
factor can be thought.
31012E10AsynchronousGet Command Status
• Input parameter is invalid.
• Port status or the MP Blade status is in the state of abnormal.
• Cable is not connected correctly.
• Port is specified incorrectly.
The operation cannot be done because the microcode is being
changed.
80042E11AsynchronousGet Command Status
The command cannot be accepted. After a while, execute the
same command.
94002E11ExecutingCMDRJE
The specified CU number is not defined, or an LDEV is not
defined under the CU number.
71012E21AsynchronousGet Command Status
The specified RCU is already registered to another product ID.30012E22AsynchronousGet Command Status
Path cannot be established because the number of RCU
registered in MCU or RCU exceeds four.
30022E22AsynchronousGet Command Status
The specified SSID is already registered to another RCU.33002E22AsynchronousGet Command Status
The specified RCU is cannot be registered because there is no
free RCU.
30002E23AsynchronousGet Command Status
The operation cannot be done because the number of paths
become less than the least path number.
31012E23AsynchronousGet Command Status
The port attribute is not Initiator (MCU).840A2E30ExecutingCMDRJE
Command cannot be executed because the RCU identification
code of a path is invalid.
30012E31AsynchronousGet Command Status
Command cannot be executed because the serial number is not
unified in the specified path.
31012E31AsynchronousGet Command Status
The command cannot be accepted. After a while, execute the
same command.
00EE2ED6ExecutingCMDRJE
An internal error occurred.30052ED6AsynchronousGet Command Status
Call HP Technical Support.
The value of SSID on the remote storage system is invalid.33002ED6ExecutingCMDRJE
Table 81 SSB codes that are returned by raidcom delete ldev command
raidcom delete ldev
DescriptionError codeExecuting/
Asynchronous
Error message
SSB2SSB1
It exceeds the range of LDEV number.00002E00ExecutingCMDRJE
This command does not support the emulation type of the
specified LDEV.
000E2E00AsynchronousGet Command Status
The specified LDEV is used as a Business Copy pair.00002E10AsynchronousGet Command Status
234 Troubleshooting