HP P9000 RAID Manager User Guide
Table 78 SSB codes that are returned by raidcom add rcu_path command (continued)
raidcom add rcu_path
DescriptionError codeExecuting/
Asynchronous
Error message
SSB2SSB1
/AsynchronousGet Command Status
The value of specified port is invalid.84002E00ExecutingCMDRJE
/AsynchronousGet Command Status
Failed to establish a path or the deletion operation. The following
factor can be thought.
31012E10AsynchronousGet Command Status
• Input parameter is invalid.
• Port status or the MP Blade status is in the state of abnormal.
• Cable is not connected correctly.
• Port is specified incorrectly.
The operation cannot be done because the microcode is being
changed.
80042E11AsynchronousGet Command Status
The command cannot be accepted. After a while, execute the
same command.
94002E11ExecutingCMDRJE
A logical path cannot be added because the specified RCU is
not registered.
30012E20AsynchronousGet Command Status
The specified CU number is not defined, or an LDEV is not
defined under the CU number.
71012E21AsynchronousGet Command Status
An RCU path cannot be added because the number of valid
paths exceeds the maximum.
31002E23AsynchronousGet Command Status
The port attribute is not Initiator (MCU).840A2E30ExecutingCMDRJE
Command cannot be executed because the RCU identification
code of a path is invalid.
30012E31AsynchronousGet Command Status
Command cannot be executed because the serial number is not
unified in the specified path.
31012E31AsynchronousGet Command Status
The command cannot be accepted. After a while, execute the
same command.
00EE2ED6ExecutingCMDRJE
An internal error occurred.30052ED6AsynchronousGet Command Status
Call HP Technical Support.
The value of SSID on the remote storage system is invalid.33002ED6ExecutingCMDRJE
Table 79 SSB codes that are returned by raidcom delete rcu command
raidcom delete rcu
DescriptionError codeExecuting/
Asynchronous
Error message
SSB2SSB1
CU# on the RCU exceeds the effective range.30012E00ExecutingCMDRJE
Invalid product ID or path registration ID.30052E00ExecutingCMDRJE
Command cannot be executed because the parameter of
specified RCU is invalid.
30082E00AsynchronousGet Command Status
The value of specified port# on the side of RCU is invalid.32002E00ExecutingCMDRJE
232 Troubleshooting