HP P9000 RAID Manager User Guide

Table 75 SSB codes that are returned by raidcom add thp_pool command
raidcom add thp_pool
DescriptionError codeExecuting/
Asynchronous
Error message
SSB2SSB1
LDEV number is out of range.00002E00AsynchronousGet Command Status
The value of pool ID is out of range.60002E00ExecutingCMDRJE
The maximum reserve ratio of V-VOL is out of range.60022E00ExecutingCMDRJE
The threshold of the specified High water mark is out of range.60092E00ExecutingCMDRJE
The operation cannot be done because the specified threshold
of Warning is larger than the threshold of the specified High
water mark.
600A2E00ExecutingCMDRJE
The specified LDEV is in the state of blocked.00092E10AsynchronousGet Command Status
The operation cannot be done because a SATA-E drive in the
state of quick formatting is in the specified LDEV.
000C2E10AsynchronousGet Command Status
The specified LDEV is in the state of blocked, or not installed.00112E10ExecutingCMDRJE
The operation cannot be performed because the pool volume
is being deleted.
600D2E10AsynchronousGet Command Status
The specified operation is not supported in the current microcode
version.
80022E10AsynchronousGet Command Status
The pool is not in the status where the pool volume can be
added.
60032E11Executing
/Asynchronous
CMDRJE
Get Command Status
The operation cannot be done because the power supply is
switched off.
80032E11AsynchronousGet Command Status
The command cannot be accepted. After a while, execute the
same command.
94002E11ExecutingCMDRJE
The specified LDEV is not installed.00002E20AsynchronousGet Command Status
The operation cannot be performed because the memory
capacity of the shared memory (SM) is insufficient.
81032E21AsynchronousGet Command Status
Thin Provisioning program product is not installed.90072E21ExecutingCMDRJE
Exceeded the number of pool volume that can be registered in
a pool.
00052E22AsynchronousGet Command Status
The larger number of drive types than the supported
configuration cannot be added to the specified pool.
000D2E22AsynchronousGet Command Status
Pool volume cannot be registered because the drive type of
specified LDEV is different from the other pool volume type, or
the drive type in the pool exceeds three.
61002E22AsynchronousGet Command Status
The emulation type of specified LDEV cannot be used as a pool
VOL.
00002E30AsynchronousGet Command Status
The specified LDEV has the LU path definition.00072E30AsynchronousGet Command Status
The specified LDEV is used as an External Storage Access
Manager quorum disk.
000C2E30AsynchronousGet Command Status
The specified LDEV is used as a system disk.000D2E30AsynchronousGet Command Status
The specified LDEV is already used as a pool volume.000E2E30AsynchronousGet Command Status
The specified LDEV is a command device.00102E30AsynchronousGet Command Status
228 Troubleshooting