HP P9000 RAID Manager User Guide

Table 71 SSB codes that are returned by raidcom delete pool command (continued)
raidcom delete pool
DescriptionError codeExecuting/
Asynchronous
Error message
SSB2SSB1
The operation cannot be done because the pool volume is not
of a specified pool.
00032E20AsynchronousGet Command Status
Pool ID is not installed.60002E20Executing/AsynchronousCMDRJE
Get Command Status
The specified LDEV cannot be deleted because it is a top VOL
of the pool.
00522E30ExecutingCMDRJE
The specified pool is a pool for Snapshot.60032E30ExecutingCMDRJE
The command cannot be accepted. After a while, execute the
same command.
00EE2EE7ExecutingCMDRJE
Pool ID is not installed.00F92EE7ExecutingCMDRJE
An internal error occurred.FEEC2EE7ExecutingCMDRJE
Call HP Technical Support.
The specified parameter is invalid. Check the HP P9000 RAID
Manager Reference Guide.
60022EF3ExecutingCMDRJE
Table 72 SSB codes that are returned by raidcom add snap_pool command
raidcom add snap_pool
DescriptionError codeExecuting/
Asynchronous
Error message
SSB2SSB1
The value of LDEV number is out of range.00002E00AsynchronousGet Command Status
Pool ID is out of range.60002E00ExecutingCMDRJE
The maximum reserve ratio for V-VOL is out of range.60022E00ExecutingCMDRJE
The specified LDEV is in the state of blocked.00092E10AsynchronousGet Command Status
The specified LDEV is in the state of blocked, or not installed.00112E10ExecutingCMDRJE
The pool is not in the status where the pool volume can be
added.
60032E11Executing
/Asynchronous
CMDRJE
Get Command Status
The operation cannot be done because the power supply is
switched off.
80032E11AsynchronousGet Command Status
The command cannot be accepted. After a while, execute the
same command.
94002E11ExecutingCMDRJE
The specified LDEV is not installed.00002E20AsynchronousGet Command Status
The operation cannot be performed because the memory
capacity of the shared memory (SM) is insufficient.
81032E21AsynchronousGet Command Status
The operation cannot be done because the SM for Snapshot is
not initialized.
81062E21AsynchronousGet Command Status
Snapshot program product is not installed.90072E21ExecutingCMDRJE
Exceeded the number of pool volume that can be registered in
a pool.
00052E22AsynchronousGet Command Status
Error messages and error codes 225