HP P9000 RAID Manager User Guide
Table 70 SSB codes that are returned by raidcom rename pool command
raidcom rename pool
DescriptionError codeExecuting/
Asynchronous
Error message
SSB2SSB1
The value of pool ID is out of range.60002E00ExecutingCMDRJE
The pool name cannot be changed because the pool
configuration is being changed.
60162E10ExecutingCMDRJE
Invalid pool ID.60002E20ExecutingCMDRJE
The pool name is duplicated with another pool.60012E31ExecutingCMDRJE
An internal error occurred.FEEC2EE7ExecutingCMDRJE
Call HP Technical Support.
Table 71 SSB codes that are returned by raidcom delete pool command
raidcom delete pool
DescriptionError codeExecuting/
Asynchronous
Error message
SSB2SSB1
LDEV# exceeds the range.00002E00ExecutingCMDRJE
The value of pool ID is out of range.60002E00ExecutingCMDRJE
All pool volumes associated to a pool cannot be deleted.600B2E00AsynchronousGet Command Status
The specified LDEV is in the state of blocked.00092E10AsynchronousGet Command Status
This pool cannot be deleted because a volume in the pool is
being deleted.
600D2E10ExecutingCMDRJE
The operation cannot be done because the pool usage rate
exceed the threshold value of the pool usage.
600E2E10AsynchronousGet Command Status
The operation cannot be done because the current capacity rate
exceeds the value of maximum reserved capacity rate.
600F2E10AsynchronousGet Command Status
It cannot be deleted because the pool volume is set in the state
of being deterred deleting.
60102E10AsynchronousGet Command Status
Deleting operation cannot be done because it is being discarded
pages.
60112E10AsynchronousGet Command Status
The operation cannot be done because a Snapshot pair remains
or the association with a Thin Provisioning virtual volume exists.
001F2E11Executing/
Asynchronous
CMDRJE
Get Command Status
The operation cannot be done because a Snapshot pair is being
deleted or a Thin Provisioning virtual volume is being deleted.
00202E11AsynchronousGet Command Status
The operation cannot be done because a pool volume of a
specified pool is being formatted.
00212E11AsynchronousGet Command Status
The pool is not in the status where the pool can be deleted or
a pool volume can be deleted.
60032E11AsynchronousGet Command Status
The operation cannot be done because the power supply is
switched off.
80032E11AsynchronousGet Command Status
The command cannot be accepted. After a while, execute the
same command.
94002E11ExecutingCMDRJE
The specified LDEV is not registered to the pool.00032E20ExecutingCMDRJE
224 Troubleshooting