HP P9000 RAID Manager Reference Guide (T1610-96037, October 2011)

R =E: Checking for data block size on Read is enabled.
D: Checking for data block size on Read is disabled.
W =E: Checking for data block size on Write is enabled.
D: Checking for data block size on Write is disabled.
E =L: Data block on Read/Write is interpreted as little endian format.
B: Data block on Read/Write is interpreted as big endian format.
E =W: Shows the Warning that Read/Write is not rejected when validation error is detected.
R: Shows the Reject that Read/Write is rejected when validation error is detected.
MR-W-B: Displays the flags for checking regarding CHK-F3 in the data block.
R =E: Checking for CHK-F3 on Read is enabled.
D: Checking for CHK-F3 on Read is disabled.
W =E: Checking for CHK-F3 on Write is enabled.
D: Checking for CHK-F3 on Write is disabled.
B =E: Checking for CHK-F3 in the data block #0 is enabled.
D: Checking for CHK-F3 in the data block #0 is disabled.
BR-W-B-Z: This column displays the flags for checking regarding CHK-F2 in the data block.
R =E: Checking for CHK-F2 on Read is enabled.
D: Checking for CHK-F2 on Read is disabled.
W =E: Checking for CHK-F2 on Write is enabled.
D: Checking for CHK-F2 on Write is disabled.
B =E: Comparing for CHK-F2 in the data block is enabled. D: Comparing for CHK-F2 in the data
block is disabled.
Z =E: The NON zero checking for CHK-F2 in the data block is enabled.
D: The NON zero checking for CHK-F2 in the data block is disabled.
SR-W-B-S: Displays the flags for checking regarding CHK-F1 in the data block.
R =E: Checking for CHK-F1 on Read is enabled.
D: Checking for CHK-F1 on Read is disabled.
W =E: Checking for CHK-F1 on Write is enabled.
D: Checking for CHK-F1 on Write is disabled.
B =E: Checking for CHK-F1 in the data block #0 is enabled.
D: Checking for CHK-F1 in the data block #0 is disabled.
S =E: Referring for CHK-F1 flag contained in the data block is enabled.
D: Referring for CHK-F1 flag contained in the data block is disabled.
Example 2: raidvchkscan command example with the -v offset option
# raidvchkscan -p CL1-A -v offset
PORT# /ALPA/C TID# LU# Seq# Num LDEV# Bsize STLBA ENLBA BNM
CL1-A / ef/ 0 0 0 2332 1 0 1024 1 102400 9
CL1-A / ef/ 0 0 1 2332 1 1 1024 1 102400 9
CL1-A / ef/ 0 0 2 2332 1 2 1024 1 102400 9
CL1-A / ef/ 0 0 3 2332 1 3 1024 1 102400 9
CL1-A / ef/ 0 0 4 2332 1 4 1024 1 102400 9
Output of the raidvchkscan command with -v offset option:
Bsize: Displays the data block size of Oracle I/O, in units of bytes.
STLBA: Displays the Start of LBA on a target volume for checking, in units of 512 bytes.
80 Replication commands