HP P9000 RAID Manager Reference Guide (T1610-96037, October 2011)

Display example for Continuous Access Synchronous Sync CTG:
# pairvolchk -g oradb
pairvolchk : Volstat is P-VOL.[status = PAIR fence = DATA CTGID = 2 MINAP = 2 ]
Display example for Continuous Access Asynchronous:
# pairvolchk -g oradb
pairvolchk : Volstat is P-VOL.[status = PAIR fence = ASYNC CTGID = 2 MINAP = 2 ]
MINAP displays the following two conditions (status) according to the pair status:
P-VOL: This shows the minimum in Active Paths on specified group in Continuous Access
Synchronous/Continuous Access Asynchronous.
S-VOL_ SSUS(SSWS): MINAP shows the result of the suspend operation that indicates whether the
remaining data on P-VOL was completely passed (synchronized) to S-VOL. If MINAP is “one”, all
data is passed. Otherwise, all data is not passed from P-VOL.
NOTE: If RAID F/W is not supporting the active paths, then the “MINAP” item is not displayed
as follows:
pairvolchk : Volstat is P-VOL.[status = PAIR fence = ASYNC CTGID = 2]
Example 2
Display example for Continuous Access Journal:
# pairvolchk -g oradb
pairvolchk : Volstat is P-VOL.[status = PAIR fence = ASYNC CTGID = 2 MINAP = 2 ]
MINAP displays the following two conditions (status) according to the pair status:
P-VOL or S-VOL_PAIR (except SSUS(SSWS)): this shows the minimum in Active Paths on specified
group in Cnt Ac-J.
S-VOL_ SSUS(SSWS): MINAP shows the result of the suspend operation that indicates whether or
not the remaining All data on P-VOL were Passed (synchronized) to S-VOL completely. If MINAP
is “one”, All data were passed. If not, all data were not passed from P-VOL.
Note: If RAID F/W is not supporting the active paths, then the “MINAP” item is not displayed as
follows:
pairvolchk : Volstat is P-VOL.[status = PAIR fence = ASYNC CTGID = 2]
Example 3
Display example for LDEV blockading:
# pairvolchk -g oradb
pairvolchk : Volstat is P-VOL.[status = PAIR fence = DATA MINAP = 2 LDEV = BLOCKED]
LDEV = BLOCKED: Displays the status of LDEV blockading in order to detect a link failure of E-LUN.
48 Replication commands