HP P9000 RAID Manager Reference Guide (T1610-96037, October 2011)

Pair vol: The paired volume name (dev_name) in the specified group which is described in the
configuration definition file.
Port targ# lun#: The port ID, TID, and LUN which is described in the configuration definition file.
For further information on fibre-to-SCSI address conversion, see the HP P9000 RAID Manager
Installation and Configuration User Guide.
LDEV#: The LDEV ID for the specified device.
Oldstat: The old pair status when the status of the volume is changed.
Newstat: The new pair status when the status of the volume is changed.
code: The storage system-internal code for the specified status.
The following table specifies the results of the pairmon command options.
Table 13 Results of pairmon command options
Actions-allsnd-resevt-nowait-D
When HORCM does not have an event, this option waits until an event
occurs. If one or more events exist, then it reports one event and resets
the event which it reported.
----D
When HORCM does not have an event, this option waits until an event
occurs. If one or more events exist, then it reports all events.
-allsnd--Invalid
When HORCM does not have an event, this option waits until an event
occurs. If one or more events exist, then it reports one event and resets
all events.
--resevt-Invalid
When HORCM does not have an event, this option waits until an event
occurs. If one or more events exist, then it reports all events and resets
all events.
-allsnd-resevt-Invalid
When HORCM does not have an event, this option reports event nothing.
If one or more events exist, then it reports one event and resets the event
which it reported.
---nowaitInvalid
When HORCM does not have an event, this option reports event nothing.
If one or more events exist, then it reports all events.
-allsnd--nowaitInvalid
When HORCM does not have an event, this option reports event nothing.
If one or more events exist, then it reports one event and resets all events.
--resevt-nowaitInvalid
When HORCM does not have an event, this option reports event nothing.
If one or more events exist, then it reports all events and resets all events.
-allsnd-resevt-nowaitInvalid
pairvolchk
The pairvolchk command checks the attributes and status of a pair volume. It acquires and reports
the attribute of a volume or group connected to the local host (issuing the command) or remote
host. The volume attribute is SMPL (simplex), P-VOL (primary volume), or S-VOL (secondary volume).
The -s[s] option reports the pair status in addition to the attribute.
Syntax
pairvolchk { -h | -q | -z | -I[H][M][instance#] or I[CA][BC][instance#]
| -g <group> | -d <pair Vol> | -d[g] <raw_device> [MU#]
| -FHORC [MU#] | -FMRCF [MU#] | -d[g] <seq#> <LDEV#> [MU#]
| -c | -ss |-nomsg }
44 Replication commands