HP P9000 RAID Manager Reference Guide (T1610-96037, October 2011)

Figure 5 Example for creating a suspended journal volume
Example 3
The following figure shows a takeover example used to suspend a journal volume.
NOTE: The pairresync command must be issued after CA_Sync volume became S-VOL_SSWS
or P-VOL_COPY/PAIR through the horctakeover command.
Figure 6 Takeover example used to suspend a journal volume
pairsplit
The pairsplit command is used to split and delete volume pairs. This command stops updates to
the secondary volume of a pair and can either maintain (status = PSUS) or delete (status = SMPL)
the pairing status of the volumes. The pairsplit command can be applied to a paired logical volume
or a group of paired volumes. The pairsplit command allows read access or read/write access to
the secondary volume, depending on the selected options. When the pairsplit command is specified,
acceptance of write requests to the primary volume depends on the fence level of the pair (data,
status, never, or async).
pairsplit 27